Working on my Helmet
To finish the best bucket available, a lot of work, patience and skill is required.
So first I had to hot glue together all the pieces from the inside in order to get a solid and sturdy helmet. I did this by glueing together the face and bumpy cap/back pieces.
Then, cause sometimes the HIPS is thinner than desired, I used epoxy glue to make it a bit thicker. This is not required but recommended to make it more trooping friendly.
Here the pictures show the hot glue on both sides of the helmet inside, and a bit of epoxy dough.
So first I had to hot glue together all the pieces from the inside in order to get a solid and sturdy helmet. I did this by glueing together the face and bumpy cap/back pieces.
Then, cause sometimes the HIPS is thinner than desired, I used epoxy glue to make it a bit thicker. This is not required but recommended to make it more trooping friendly.
Here the pictures show the hot glue on both sides of the helmet inside, and a bit of epoxy dough.
0 Comments:
Post a Comment
<< Home